MPLS LDP Basic Configuration on NCS 540
This guide explains configuring NLS LDP on Cisco NCS 540 using the ISIS protocol, detailing both manual and automatic methods for enabling LDP on interfaces.
MAIN POINTS FROM TRANSCRIPT
- NLS LDP configuration begins with enabling it globally and assigning a router ID.
- Manually enable LDP on interfaces by specifying each interface and committing changes.
- Automatic LDP configuration can be achieved using the "NLS LDP autoconfig" command within the IGP.
- Verify configurations and neighbor discovery using specific show commands.
TAKEAWAYS
- Assigning a static router ID is a best practice for consistency in network configurations.
- Automatic LDP configuration reduces errors and saves time when dealing with multiple interfaces.
- Consistent use of the same ID for both IGP and NLS is recommended.
- Regularly verify LDP settings and neighbor status to ensure proper network operation.